Concrete Vibrator, 3/4HP 800W Electric Hand Held, 1.2M Hose, Pack of 2 H314224

NOTE: To assemble the hose to the unit: it is a reverse thread. When the vibrator is installed and powered on, it must be knocked to the ground to vibrate How to use: Maintenance and inspection Before any work on the machine itself, pull the mains plug. The brushes should be checked periodically and warm-out brushes should be replace in time,after replacing,inspect,whether the new brushes can move freely in the brush holder,keep running the motor for 15 minutes to match the contact of brushes and commentators. Keep the ventilation slots clear from dirt , clean off the accumulated dust and oil dirt periodically. During normal operation , if anything happens ,the power supply should be cut off at once and the tool should be checked and repaired Regular inspect all mounting screws and ensure that they are properly tightened, should any of the screws be loosen,Tighten them immediately, failure to do so could result in personal injury Do not expose the tool to rain , Do not use power tools in damp or wet location ,keep work area well lit do not use power tools where there is risk to cause fire or explosion. Feature: Professional machine Stable voltage 800w, safe to operate Hand held Well constructed with quality materials Powerful and safe concrete vibrator Flexible shaft Hard Nose with flexible shaft for hard to reach places Shaft simply screws on to drive unit, no other tools required Lift time to use Electric control Easy to use labour saving tool to help settle concrete and remove air bubbles from slabs & footings Specifications: Rated current: 2.8 A Rated voltage: 220 V/110V Frequency: 50 Hz/60Hz Needle diameter: 35 mm Shaft length: 120 cm Total weight: 6.3 kg Package Content: 1 × 800W Concrete Vibrator 1 × 1.2m Hose